Skip to content
Independent guides to preserving gear, est. 2026

Canning, drying, storing and harvest gear for home kitchens

We independently pick everything we recommend. We earn a commission when you buy through our links, at no extra cost to you. Learn more ›
Amazon Black Friday Week deals
Can You Use a Chest Freezer as a Refrigerator?
Storage

Can You Use a Chest Freezer as a Refrigerator?

Can you use a chest freezer as a refrigerator? Yes, with an external temperature controller: how the setup works, which controller figures to compare, and what to check first.

On this page

Top picks at a glance

As an Amazon Associate I earn from qualifying purchases.

  1. 1KoolMore 7 Cu. Ft. Garage Ready Convertible UprightKoolMore 7 Cu. Ft. Garage Ready Convertible Upright9.8/10View on Amazon
  2. 2Tehanld 1.8 Cu.Ft Chest FreezerTehanld 1.8 Cu.Ft Chest Freezer9.6/10View on Amazon
  3. 3DEMULLER Chest Freezer 4.0 CU. FT Ultra-low Temperature DeepDEMULLER Chest Freezer 4.0 CU. FT Ultra-low Temperature Deep9.6/10View on Amazon
  4. 4Temperature Controller Fit Commercial Refrigerators/FreezerTemperature Controller Fit Commercial Refrigerators/FreezerView on Amazon
  5. 52 Pack Refrigerator Thermometer2 Pack Refrigerator ThermometerView on Amazon
  6. 64PACK Refrigerator Thermometer -30-30 deg C/-20-80 deg F4PACK Refrigerator Thermometer -30-30 deg C/-20-80 deg FView on Amazon
  7. 7BLACK+DECKER 17 Cu. Ft. Convertible Freezer RefrigeratorBLACK+DECKER 17 Cu. Ft. Convertible Freezer RefrigeratorView on Amazon
  8. 8BLACK+DECKER 14 Cu. Ft. Convertible Freezer RefrigeratorBLACK+DECKER 14 Cu. Ft. Convertible Freezer RefrigeratorView on Amazon
  9. 9LinkDm 4 Pack Refrigerator Freezer Thermometer Large DialLinkDm 4 Pack Refrigerator Freezer Thermometer Large DialView on Amazon

A spare chest freezer in the garage, a harvest that needs cold storage, and a kitchen fridge that is already full: the question comes up every season. Can you use a chest freezer as a refrigerator? Yes, with an external temperature controller that switches the freezer on and off at fridge temperatures, because a chest freezer on its own runs far colder than a fridge and its own dial has no setting for fridge use. This guide explains how the setup works, which figures to compare, and what to check before you load food.

Runners-up to consider

HarvestGearLab earns a commission when you buy through links on this site, at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Affiliate disclosure.

Can you use a chest freezer as a refrigerator: the short answer

Yes, with a controller in between. A chest freezer is a compressor appliance built to hold frozen food, and its own thermostat cannot hold fridge temperatures. An external controller plugs into the wall outlet, the freezer plugs into the controller, and a probe inside the cabinet reads the temperature. When the cabinet warms past the set point, the controller switches the freezer on; when it cools to the set point, it switches it off. The listings we compared are all controllers of this kind, and they differ in load rating, temperature range and probe length.

Controller What it does Stated range Stated load
Inkbird ITC-308 WiFi Plug-in controller with Wi-Fi monitoring through the INKBIRD app Not stated 1100 W at 110 V
DEWENWILS thermostat outlet Plug-in controller with heating and cooling modes -40 to 210°F 1800W, 15A output
KETOTEK thermostat outlet Plug-in controller with a probe for heating and cooling -40°C to 120°C (-40°F to 248°F) 15A at 120V
ToolSentryX XR06CX replacement Panel controller for commercial refrigeration -67°F to 210°F Not stated

Start with the controller, not the freezer

Pick the controller first, because it does the work the freezer cannot. The Inkbird ITC-308 WiFi (on Amazon) lists dual relay outputs and an alarm when the temperature reaches the preset temperatures or the sensor malfunctions. The DEWENWILS outlet lists heating and cooling modes with a VA display, power memory that restores previous settings, and temperature calibration for fine-tuning. The KETOTEK outlet (on Amazon) lists heating and cooling modes, a timing function, built-in memory that retains settings in case of power outage, and temperature calibration.

Wi-Fi monitoring is an extra, not a requirement: only the Inkbird ITC-308 WiFi lists it, with 2.4 GHz Wi-Fi and the INKBIRD app for remote control.

A controller sized by load

Match the controller to the freezer by the load figures the listings state. The Inkbird ITC-308 WiFi lists a maximum output load of 1100 W at 110 V, and the Inkbird ITC308 (on Amazon) lists 1200W at 110V. The DEWENWILS outlet lists a 15A output and up to 1800W heating capacity, and the KETOTEK outlet lists a maximum output of 15A at 120V. Pick a controller whose stated maximum covers the freezer.

Range and precision matter as much as load. The DEWENWILS outlet lists a range from -40 to 210°F with a precision of 0.1°F. The KETOTEK outlet lists a range from -40°C to 120°C (-40°F to 248°F) with control accuracy of ±1°C/±2°F. The ToolSentryX XR06CX (on Amazon) lists precision control from -67°F to 210°F. The Inkbird ITC-308 WiFi lists no range in its listing, so the range figure is not stated for that controller. Probe length decides where the sensor can sit: the KETOTEK outlet lists a 9.8ft probe with a 3-meter NTC sensor, while the other plug-in listings state no probe length.

How the setup works, step by step

The Inkbird ITC308 listing sums up the setup in four moves: plug it in, set the temp ranges, place the probe, and plug the heater or cooler into the marked outlet. For a chest freezer used as a refrigerator, the moves are the same: plug the controller into the wall outlet, set the temperature range on the controller, place the probe inside the freezer cabinet, and plug the freezer into the marked outlet on the controller. The controller then switches the freezer on and off as the probe reading changes.

Set the range on the controller, not on the freezer dial, and leave the freezer dial where the controller manual says. Check the reading with a thermometer in the cabinet: our best freezer thermometer picks and our best wireless refrigerator thermometer picks compare the options. If the controller supports calibration, use it to line the probe reading up with the thermometer, as the Inkbird, DEWENWILS and KETOTEK listings all state temperature calibration.

What to check before you switch over

  • Load rating. Compare the freezer against the controller maximum: 1100 W for the Inkbird ITC-308 WiFi, 1200W for the Inkbird ITC308, and 1800W for the DEWENWILS outlet.
  • Range. Check the stated range covers fridge use: the DEWENWILS outlet lists -40 to 210°F, the KETOTEK outlet lists -40°C to 120°C, and the ToolSentryX XR06CX lists -67°F to 210°F.
  • Probe placement. Place the probe inside the cabinet where it reads cabinet air, and keep it clear of the lid seal so the lid still closes.
  • Power memory. The DEWENWILS outlet restores previous settings after a power cut, and the KETOTEK outlet retains settings with built-in memory. Check the listing for your controller.
  • Warranty. The DEWENWILS and ToolSentryX listings state a 1-year warranty. The other listings state no warranty term.

Once the controller is running, watch the thermometer before you load food: a controller that holds the set point is the sign the setup is working as the listings describe.

What to skip or double-check

  • A controller rated below the freezer. Skip any controller whose stated maximum load is below the freezer draw.
  • Panel controllers without a wiring plan. The XR06CX listings are replacement panel controllers for commercial refrigeration, and they recommend power disconnection during installation and checking that the power supply voltage is stable before connecting. A plug-in outlet controller needs no wiring.
  • The freezer dial. Do not rely on the freezer dial to hold fridge temperatures; that is the controller job.
  • Probe in the lid seal. Double-check the probe cable is not pinched in the lid seal, which would leave a gap in the seal.
  • Display units. Double-check whether the controller shows Celsius or Fahrenheit: the Inkbird, DEWENWILS and KETOTEK listings all support both.

What this guide does not cover

This guide does not give temperature settings or storage times, because they depend on the food, the controller and the room. Take food safety guidance from current USDA guidance, and follow the controller manual for installation and settings.

FAQ: preserving at home

Can a chest freezer work as a refrigerator without a controller?

No. A chest freezer on its own runs as a freezer, and its own dial has no setting for fridge use. The external controller is what switches the freezer on and off at fridge temperatures.

What does a temperature controller do?

It sits between the wall outlet and the freezer, reads the temperature from a probe inside the cabinet, and switches power to the freezer on and off. The Inkbird ITC-308 WiFi lists dual relay outputs for refrigeration and heating equipment.

How do I pick a controller for a chest freezer?

Compare the load rating first: 1100 W for the Inkbird ITC-308 WiFi, 1200W for the Inkbird ITC308, and 1800W for the DEWENWILS outlet. Then compare the range, the probe length and extras such as Wi-Fi monitoring.

Can I monitor the temperature from my phone?

Only the Inkbird ITC-308 WiFi listing states it: 2.4 GHz Wi-Fi with the INKBIRD app for remote control. The other listings state no Wi-Fi.

What happens if the power goes out?

It depends on the controller. The DEWENWILS outlet lists power memory that restores previous settings, and the KETOTEK outlet lists built-in memory that retains settings in case of power outage. Check the listing for the controller you pick.

More preserving guides

See our medium size chest freezer sizes and capacity guide, our best freezer thermometer picks and our best wireless refrigerator thermometer picks.

More picks: freezer thermometers, analog refrigerator thermometers, freezer containers and freezer bags for meat.

Read next in the kitchen